Sentryline – M® Wire Rope Barrier

Description

The Sentryline – M® Wire Rope Barrier is a high-tension cable barrier, with an accompanying terminal end, designed and tested for full compliance with MASH (2016) levels TL-3 and TL-4. Sentryline – M® Wire Rope Barrier allows an impacting vehicle to be re-directed in a safe and predictable manner under MASH 2016 impact conditions.

Features:

• Tested to MASH (2016) TL-3 and TL-4 by Holmes Solutions
• Approved by Austroads Safety Barrier Assessment Panel (ASBAP)
• Easily installed with minimal maintenance required

Downloadable Resources:

Sentryline-M Wire Rope Barrier System Brochure

Sentryline-M Wire Rope System General Arrangement

Sentryline-M Wire Rope Barrier Terminal End Overlapping Detail

Sentryline-M Wire Rope Unit White - Concrete Block Option BOM

Specifications:

• Cable – 19mm 3 x 7 strand, pre-stretched by 35%
• Cable heights (to the centre) as per drawing FX748
• Typically Line Post footing piles are 300mm diameter x 750mm (0.05m3)
• Length of Need is met at Transition Line Post 5
• Tensioned to 25kN at 20°C (Tension may vary depending on air temperature at time of installation, see chart in Product and Installation Manual)
• Max flare, 300mm over 10m of the terminal end (offset from tangent)
• All components are hot dip galvanised (posts are all hot dip galvanised with an optional powder coated finish)
• Concrete is 25MPa

Standards and Approvals:

• AS/NZS 3845 – Part 1 Products
• MASH (2016) TL-3 & TL-4 tested by Holmes Solutions
• Approved by Austroads Safety Barrier Assessment Panel (ASBAP)